3001X / Version 2
The earlier universal board and its specific connections.
On this page
Check historical identifiers
The original PDF linked under 3001X calls itself Version 2 and lists 3007, 3008 and 3009 for yellow, white and warm white. The current range uses article numbers including 30017 and 30019. Compare your board with the drawing; for older units, the manual filename alone is not sufficient identification.
Version 2 specifications
The manual describes 14 LEDs, constant brightness from 5 V AC/DC, a maximum of 25 V AC/DC, average current below 45 mA and dimensions of 230 × 10 × 3.5 mm including components. The drawing marks two potentiometers. This is potentiometer-controlled lighting, which does not imply DCC programmability.
IN, SL and capacitor pads
Inputs IN-1 through IN-5 are connected in parallel; supplying one input is sufficient. This manual describes the SL connections for two red LEDs in parallel without an additional resistor. That does not automatically apply to LX-U Poti contacts 2/4. Use only the marked, polarised capacitor pads and check capacitor compatibility.
Cut points and remaining sections
The drawing marks the two cut positions with dashed lines. The manual says the approximately 32 mm offcut that may result is only usable in limited circumstances. This is not a complete connection specification for independent operation. Ask about your intended use with photos of the offcut and original board before applying power.
Original PDF manuals
German originals. See the notes in this guide before using historical specifications.